SINEWAVE GRINFINEON CONTROLLER MANUAL
Rev 2.1
-3-
1
Introduction
The Grinfineon SineWave controller is based around the popular Xie Chang
device with the XCKJ3232C control chip, but with custom firmware to allow both
sensored and sensorless operation and proportional regenerative braking. The
generous cable harness lengths and crimpable connector standards make it
broadly useful in aftermarket and DIY ebike applications for just about any
geared or direct-drive brushless motor in the 500-3000 watt power range.
1.1
Key Features
Here are some of the features that make this controller stand out which you won’t
usually find with most 3
rd
party ebike motor controllers
•
Long phase leads (120cm)
•
On/Off Switch
•
Proportional Regenerative Braking
•
Dual Mode, works With and Without Hall Sensors
•
Silent Sine Wave Operation in Sensored Mode
•
High Sensorless eRPM Compatible with Geared Motors
•
Fwd/Rev Input
•
LED Status Indicator
•
Watertight Enclosure
•
Direct Cycle Analyst Plug
•
User Crimpable Connectors (JST-SM and Anderson Powerpoles)
Figure 1: Key Controller Hardware Features
