ENCLOSURE INSTALLATION
Locate the enclosure within 10,000 ft (3,000 m) of the pressure sensor. It can be wall mounted with four
mounting screws (supplied) or panel mounted with Option PM Panel Mounting Kit from Greyline
Instruments. Avoid mounting the enclosure in direct sunlight to protect the electronics from damage due
to overheating and condensation. Seal conduit entries to prevent moisture from entering enclosure.
NEMA4X (IP66) WITH CLEAR COVER
1. Remove enclosure cover.
2. Insert #6 screws through the four enclosure mounting holes to secure
enclosure to wall or mounting stand.
3. Replace Cover
An additional conduit hole can be cut in the end of the enclosure if
required. Use a hole saw or Greenlee-type hole cutter to cut the required
holes.
Note:
1 This non-metallic enclosure does not automatically provide grounding between conduit connections.
Grounding must be provided as part of the installation. Ground in accordance with the requirements
of the National Electrical Code. System grounding is provided by connecting grounding wires from
all conduit entries to the steel mounting plate or another point which provides continuity.
2 Water tight “O” ring seals must be used if cable strain-reliefs are used.
Page 19
TFT32 Tank Farm Transmitter
Manual Series 2.4
END VIEW
ENCLOSURE
MOUNTING
HOLES
ENCLOSURE
COVER
