Page 12
SKU 65162
For technical questions, please call 1-800-444-3353.
Move the Trencher to the work area
2.
(See “Starting The Engine” - page
14).
Start the engine and use the Boom
3.
Controls to curl the bucket toward the
boom without touching the ground.
Moving the Bucket As sembly (32)
down to the ground will raise the
Frame Assembly (90). Lift the Tires
just off the ground and stop.
Ensure the controls will not be
4.
touched or bumped, and that the
Trencher will remain motionless.
Never place any part of your body
under the trencher.
With the Tires (52) off the ground,
5.
remove the Wheel and Axle (50)
to the operator’s left and replace
with the left side Extension Leg (19)
and Leg Assembly (24). Direct the
Extension Leg so it turns toward the
Bucket end of the Trencher. Secure
with Lock Pin No. 2 (82). Repeat
procedure for the right side. Raise
Bucket As sembly again to lower onto
Leg Assembly, and turn Engine off.
Using a jack and jack stands (not
6.
included), raise up the engine end of
the trencher and disconnect from the
towing hitch. Slide the Wheels and
Axles (50) into the engine end of the
Frame (90). Secure each axle with
Lock Pin No. 2 (82).
Purging the cylinder
Remove all Safety Locking Pins (15),
1.
disengage the Safety Latch (41) and
loosen Hydraulic Tank Fill Plug (11).
Press forward on the Boom Swing
2.
Lever (located on Control Panel (9)
until the Boom stops moving, then
pull back on it until it moves in the
other direction. Center the Boom.
Press forward on the Main Boom
3.
Lever until the Main Boom is fully
raised. Then, press Forward on the
Boom Extension Lever until the Boom
is fully extended.
Press forward on the Bucket Lever
4.
until the bucket is fully extended. Pull
back on the lever to retract it fully.
Pull back on the Boom Extension
5.
Lever until the Boom is pulled back
all the way. Pull back on the Main
Boom Lever until the Main Boom is
lowered completely.
Adjust the boom back to its rest
6.
position and replace all locking
devices.
Shut off the Engine, check the
7.
Hydraulic Fluid level and refill as
necessary.
Note: The Fill Plug is vented. When
8.
tightening the Fill Plug, tighten it
securely then back it off slightly.
oPerating inStructionS
read the entire iMPortant
SaFety inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Starting the engine
inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. if any
REV 09i