T02.0.3X.6C-07
Mounting and operating manual OXY 3610 MP
Page 6 von 14
3
Installation and Commissioning
3.1 General installation instructions
Loosen screws (A).
Remove cover (B)
Wall mounting screws (C) are not included.
The mounting-hole-diameter is 4.2 mm.
See pattern drilling above (50 x 70 mm).
Release the screw (a).
Unplug the connector.
Release the connection sealing, cable fitting
(b), shim (c) and sealing-ring (d).
Pull out the connection socket (f).
Thread cable through parts (b), (c), (d) and
into connector-housing (e).
To mount the connection cable 2-, 3-, or 4-
wire depending on type of device see chap-
ter 4 Assignment of elbow-type plug, the an-
gle plug screw has to be loosened.
Reattach part (f) in (e).
Reattach parts (d) and (c) and tighten (b).
Plug in the connector with connection sealing
and tighten (a).
Connect the ph electrode at the BNC socket
(
I
).
Connect the sensor at the 5 pole diode
Pattern drilling for
wall
mounting
50 x 70 mm
