H74.0.05.6C-06
Operating Manual GMH 3651
page 8 of 18
DA.,N
[ONC
Analogue output is showing concentration in mg/l or in ppm
SAT
or
P 02
Analogue output is showing partial pressure in %, hPa or mmHg (
(H 2
)
DA[.0
0.0...100.0
%O
2
Measuring value which should correspond to output 0 V
DA[. 1
0.0...100.0
%O
2
Measuring value which should correspond to output 1 V
e.g. 100.0 % -> 1 V (ex works
100,0 %O
2
)
SET
(ORR
Set Corr: Input adjustment
0FFS
°C or °F
-5.0
°C ..
5.0
°C
or
-9.0
°F
.. 9.0
°F
The zero point of the temperature measuring is shifted for the entered
value.
This can be used to compensate sensor and instrument deviations
OFF
No zero adjustment for temperature measurement (=0.0°)
S[AL
°C or °F
-5.00 ... 5.00
%
The slope of the temperature measurement is corrected by this value.
This can be used to compensate sensor and instrument deviations
OFF
No slope adjustment for temperature measurement (=0.00)
0FFS
hPa
-20
..
20
hPa
The zero point of the pressure measuring is shifted for the entered value.
This can be used to compensate sensor deviations
OFF
No zero adjustment for pressure measurement (=0.0°)
SET
AL
Set Alarm:
AL. 1
ON
/
NO.SO
Monitoring Oxygen: Alarm on with buzzer / Alarm on without buzzer
OFF
No alarm monitoring for oxygen
AL.,N
[ONC
Monitoring Oxygen: Concentration in %
P. 02
Monitoring Oxygen: Partial pressure in hPa or mmHg
A 1.LO
e.g.
0.0..100.0
%
Min alarm limit oxygen (not if AL. 1. oFF)
A 1.H,
e.g.
0.0..100.0
%
Max alarm limit oxygen (not if AL. 1. oFF)
AL. 2
ON
/
NO.SO
Temperature monitoring : Alarm on with buzzer / Alarm on without
buzzer
OFF
No alarm monitoring for temperature
A2.LO
-5.0 ..
+
50.0
°C
Min alarm limit temperature (not if AL. 2. oFF)
A2.H,
-5.0 ..
+
50.0
°C
Max alarm limit temperature (not if AL. 2. oFF)
SET
LO66
Set Logger
FVNC
(Y(L
Cyclic
logger function
* 9
STOR
Store
: manual recording
OFF
No logger activated
(Y(L
0:0 1
…
60:00
Cycle time in [minutes:seconds] for cyclic logger
*
SET
(L0(
Set Clock
(L0(
HH:MM
Clock
: set time
hours:minutes
YEAR
YYYY
Year
: set year
DATE
TT.MM
Date
: set date
day.month
P
ressing “menu” and “store” at the same time for more than 2 seconds will reset the
device to factory defaults
If there are data sets stored and logger is set to “manual recording” (“Func Stor”) the first
menu point displayed is “rEAd Logg” (p.r.t. chapter 9)
If no key is pressed for more than 2 minutes the configuration will be aborted. All changes will
not be saved!
