GreenWorks 26032, Руководство пользователя

Страница: 20 / 28

MAINTENANCE
20
REPLACING THE LARGE BELT (See Figures 14-16)
• Remove the 4 screws that secure the left side plate to the frame of the Snow Thrower (Fig.
14). Remove the side plate.
• Pull the bearing away from the small pulley. Remove the belt from the large pulley and the
small pulley that is located inside the housing (Fig. 15).
• Position the new belt over the small pulley (Fig. 16).
• Rotate the rotor with the left hand while positioning the belt on the large pulley with the right
hand (Fig. 16).
• Install the left side cover, and secure it using the 4 screws.
STORAGE
• Run the Snow Thrower for a few minutes in order to melt any snow that may be left on the
Snow Thrower.
• Disconnect the extension cord from the Snow Thrower.
• Inspect the extension cord thoroughly for signs of wear or damage. Replace it if it is worn or damaged.
• Inspect the Snow Thrower thoroughly for worn, loose, or damaged parts. If any parts must be
repaired or replaced, contact the Toll-Free Helpline, at 1-888-909-6757.
• Store the extension cord with the Snow Thrower.
• Store the Snow Thrower in a clean, dry place. Cover it in order to provide added protection.
Fig. 14 Fig. 15
Fig. 16
Bearing
Bearing
Left side cover Large pulley
Large pulley
Small
pulley
Small
pulley
Belt
Belt
Screw