10
1. Starting: To start the tool, simply squeeze the switch
trigger.
2. Stopping: Release the switch trigger to stop.
Note: Tool speed is increased by adding pressure
on the switch trigger.
Hold the tool firmly and place the point of the driver
bit in the screw head. Apply forward pressure to the
tool to the extent that the bit will not slip off the screw
and turn the tool on to start operation.
Starting and stopping
Run-on Brake
Reversing switch action
CAUTION:
When the switch trigger (4) is released, the chuck brakes
to a stop, thus preventing the run-on of the tool.
When driving in screw, wait until the screw is screwed in
flush with the material and then release the switch trigger
(4). By doing so, the head of the screw does not penetrate
into the material.
1) This tool has a reversing switch to change the
direction of rotation. Depress the reversing switch
lever from the A side for clockwise rotation or from
the B side for counterclockwise rotation.
2) When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
1) Always check the direction of rotation before operation.
2) Use the reversing switch only after the tool comes to
a complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
3) When not operating the tool, always set the reversing
switch lever to the neutral position.
CAUTION:
1) Always be sure that the tool is switched off and the
battery pack is removed before carrying out any work
on the tool.
Use the reversing switch only after the tool comes to
a complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
Installing or removing driver bit or socket bit
1. To install the bit, pull the sleeve (2) in the direction shown
by the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
2. To remove the bit, pull the sleeve in the direction on
the arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve, the
sleeve will not return to its original position and the bit will
not be secured. In this case, try re-inserting the bit
according to the instructions above.
NOTE:
1) Use the proper bit for the head of the screw/bit that
you wish to use.
2) When fastening screws M8 or smaller, carefully adjust
pressure on the switch trigger so that the screw is not
damaged.
3) Hold the tool pointed straight at the screw.
OPERATION FOR CORDLESS IMPACT DRIVER
Switch trigger
Reversing switch
lever
1. Bit
2. Sleeve
1
2
ENGLISH
Slower
Faster
FWD
REV
