www.greenoks.com.tr
[EN]
8
USE OF CONTROL PANELS
Digital Set Top Model Convectional Ovens’ Control Panel
• The device
measures temperature with 1 piece J type thermocouple.
• The device performs temperature control with 1
piece heater output.
• The device controls the fan speed with 2
pieces cycle outputs.
• The device makes lighting control with 1
pieces relay output.
• The unit performs system check with 1
pieces relay.
• The device can control fan direction with 2
pieces different direction relays.
• The appliance is equipped with an audible signal at the end of the cooking period and control
of the cooking time.
• The device is capable of giving automatic steam
for each prohram.
• The device has 20 program capacities.
• Each program can be used with up to 5 step steps. (parametric property.)
• The device is suitable for door control.
• The device switches off the system by giving a breakdown in case of rupture an
d
temperature rupture.
PANEL INTRODUCTION
KEY DEFINITIONS:
ON OFF BUTTON: Used to switch on the device when the device is switched off.
If pressed, the timer and device are switched on in the timer display mode. Device
the device switches off when it is pressed during operation. In this case, the
Off writes the message.
START BUTTON: It can be used in an open device. Heating operation
Starts. If pressed, the display will show the Strt message.
STOP BUTTON: If this button is pressed in the start state (heating)
the heater is switched off. Timing operations are also canceled. If the alarm is working, the
circuit is
it stays out. When pressed, the message Stop is printed on the display.
FAN DEFROST BUTTON: To start defrosting or to cool the oven
It is used.
STEAM BUTTON: The user makes the steam process with this button. Vapor
The U-ST message is displayed on the display.
LAMP BUTTON: Perform lighting control when the device is on or off
using for. If the key is pressed, the LGHT message is displayed. Lamp
The LAMP led is on while on.
TIME PLAY PAUSE BUTTON: Start the cooking time countdown event and
Pause.
The TIME indicator and the TIME indicator point flash while counting. In Pause
The TIME led and the TIME indicator point remain lit.
TIME ADJ BUTTON: This is the time shown on the display when the system is off
it will be adjusted by pressing the button.
TIME STOP BUTTON: Press this button after playing time
counting process is finished. The TIME led goes out.
