www.greenoks.com.tr
[EN]
9
WAKEUP BUTTON: Press this button once when the system is on
the tripping process is switched on or off. When activated TEMP displays ON. If disengaged,
no message is shown on the screen.
If the same button is pressed for 3 seconds, OPEN will be displayed. Opening here
time is set.
SET TEMP BUTTON: Used for entering temperature setpoint setting
This is the button. Set + Step number is shown on the display when pressed. Other
the set value will be displayed on the display.
SET TIME BUTTON: Used to enter cooking time setpoint setting
This is the button. If pressed, the display shows the T + Step number. Other
the set value will be displayed on the display.
SET STEAM BUTTON: Used for entering steam time setpoint setting
This is the button. If pressed, the display shows the STE + Step number. Other
the set value will be displayed on the display.
ENTER BUTTON: Value is used to save and confirm data.
REVIEW BUTTON: Used to monitor the entire program when the system is on.
When the system is off, it is used to control opening time and opening status.
ESC BUTTON: To exit the menus and end the value entry
used.
PROGRAM BUTTON: Used for program selection and recording.
PARAMETER BUTTON: Used for parameter input.
STEP BUTTON: To access the next step data during set value input
used.
Program Menu:
Program selection and saving operations will be described here. If P key is pressed once while
the system is on, P NO message is displayed on the left display. The other display shows the
current program number. Arrow keys to the desired program number progress and regression
is done.
Press ENT or P to select the program again. If this menu is entered by mistake, it will be
enough to wait 10 sec without pressing any button. Or press ESC to exit the menu.
To save the program, press the P key for 3 sec. The recording process is complete when the
dispenser starts blinking.
Set Temperature Adjustment:
SET TEMP BUTTON a 1 time when the system is on
makes. The display shows Set + Step number.
If stepped operation has been opened in the system, the step pad will be changed and the
step button
by switching to other steppes. The step number can be monitored from both leds and display
messages.
If stepped operation is not active, the LEDs will not light and the other steppers cannot be
accessed with the step button.
The change will be activated by pressing the Arrow keys in this menu. The degree value input
can be made between the upper temperature parameter set by 50 and the set value. Press
ENT button to save. Press ESC button or wait to exit without saving.
Set Time Set:
When the system is ON, SET TIME BUTTON is pressed 1 time to enter the time change
process. The display shows the T + Step number.
If stepped operation is opened in the system, the step pad will be changed and the step
button can be pressed to switch to other steppes. The step number can be monitored from
both leds and display messages.
If stepped operation is not active, the LEDs will not light and the other steppers cannot be
accessed with the step button.
