INSTALLATION INSTRUCTIONS
FOR PORTABLE XENON TRIPOD FLOODLIGHT
- TXT
400
Y
IMPORTANT SAFETY INFORMATION
ELECTRICAL SAFETY
This worklight must be earthed. If it becomes necessary to rewire the plug please
follow these guidelines. Always secure wires in plug terminals carefully. Make sure the
cable is firmly located in the cord grip. NEVER connect the green & yellow wire to any
terminal other than one marked with the earth symbol ‘E’ or ‘
’.
Regularly inspect all electrical connections and wiring for damage. Any faults should
be immediately rectified before further use of the worklight. Always have the wiring
and connections checked by a qualified electrician. In use, ensure all wiring and
extension cables are kept clear of any cutting tools, sharp objects and any other
potential hazards such as wet floors, chemicals & solvents etc.
Note:
If your mains wiring differs in any way from Fig
1
. Consult a qualified electrician.
Always replace the fuse with one of an identical rating.
1
. The tripod stand is supplied assembled. To attach the floodlight you must first
erect the stand.
2
. To open the legs push the spring pin upwards and, at the same time pivot the leg
down. Release the spring pin whilst pivoting the leg and the pin will locate into one
slot (see Fig
2
).
3
. To alter the stand height twist the locks (B) anti-clockwise to release, slide the tubes
to desired height and tighten the twist locks clockwise (see Fig
3
).
4
. Unscrew the centre control (A). Position the centre hole on the floodlight bracket
over the top of the stand. Re-insert the centre screw control (A). The floodlight can
be swivelled if required, by loosening the centre screw control (A) and rotating the
floodlight to the desired angle, and re-tightening. The stand has an integral cable
tidy (D) for safe storage of the mains cable when not in use.
5
. To adjust the floodlights angle, loosen the screws located on either side of the
bracket, until the desired angle is achieved, then re-tighten.
6. Check the floodlight is secure and that the stand is stable and has a firm footing.
7
. Ensure the cable is not catching on any sharp object and that the mains plug
connection is adequately protected against rain or moisture.
8. Your worklight is now ready for use.
Blue: Neutral to ‘N’ Terminal
Brown: Live to ‘L’ Terminal
Green & Yellow: Earth
Terminal
Fig
1
ASSEMBLY AND USE
