1.
To fit the supplied Xenon lamp you need to loosen the screw (E) securing the
hinged front cover and swing the cover down. The lamp is attached by spring
loaded holders at each end.
2.
Gently locate the lamp into position ensuring good contact at both ends. Take care
not to touch the glass of the lamp, if this does occur clean the lamp with methylated
spirit.
3.
Close the hinged front cover and re-tighten the top retaining screw(E).
DO NOT OVERTIGHTEN,
THIS MAY DAMAGE THE GLASS
Note: The lighting direction cannot be adjusted downwards.
CAUTION:
This unit can become extremely hot whilst in operation, do not touch the unit until it
has had time to cool down. Make sure the worklight is far enough away from any
combustible materials and/or surfaces. Make sure there is adequate ventilation to aid
heat dissipation.
INSTALLER -
Please pass instruction manual
onto the owner of the unit
Please keep these instructions
for future reference.
WEST ROAD . HARLOW
ESSEX . CM
20 2
BG . UK
WWW.GREENBROOK.CO.UK
Is
s
u
e
N
o
:
7
0
2
1
9
2
PART IDENTIFICATION
A. Centre Screw Control
B. Twist Locks
C. Leg Hinges
D. Cable Storage
E. Floodlight Housing
Retaining Screw
FITTING THE LAMP
A
B
C
D
E
Fig
2
Fig
3
Spring Pin
TECHNICAL DATA
Power Source:
110V-50Hz
IP Rating:
IP54
Xenon Lamp:
Class C
400
W max
Power Cord:
H05RN-F 3G1.0
mm
2
Max Stand Height:
2M
Glass Size:
133 x 92 x 4
mm
