page 13 of 20
Copyright © 2020 Green-GO
MCXD user guiDe
GO
Set User -
When starting to use a beltpack or other station, you can choose which User profile to use. The User profile has been set
up in the Configuration File. In the Factory Default Configuration file you can find Users like Stagemanager, FOH, Monitor,
Director etc. Choose the one that fits best.
SideT
Side Tone is the users own voice. A volume can be set for how high the users own voice should be in his/her own speakers/
headset. This can be done in the Setup Menu: Audio settings/SideT
Talk -
Is to enable your microphone audio to be transmitted to an assigned channel. (user or group) This is done by pressing the
Talk pushbutton for the desired Channel(User/Group)
Threshold
Threshold is the maximum level at which the microphone should avoid transmitting the audio that it picks up. Users have in-
dividual voice levels, individual ways of positioning the microphone and one microphone has different sensitivity than others.
To avoid unwanted audio to be transmitted, like breathing set the threshold, if necessary.
Tone
The level of the audio signal. Used for Alert, Cue, Connection status and Battery status. The volume can be set in Setup
Menu:‘Options/Tone’
User
You’re a User. Everyone using the intercom are Users. Users can be part of Groups. Custom Users and Groups can be
created in the Green-GO Control software. When created, the User gets a named profile and is automatically saved in the
Configuration File (see Config File for further information). That user can then be loaded onto any device and can be loaded
on to several devices at the same time.
The Setup Menu
The following will introduce you to the Setup menu. Where to find what you are looking for and a complete list of the Setup
Menu with notations.
The Sections
–
Program In/Program Audio:
This section allows you to set parameters for the Program Audio
–
Channel Assignment:
You have 32 channels available. Here you can assign Groups and Users to those chan-
nels. Audio Settings: Here you can load Audio profiles and set the options for your speech input.
–
Options:
You will find general options here
–
Line In/Out:
Adjust settings for Line In and Out
–
GP Input/Output:
GPIO - General Purpose Input Output conditions can be configured here.
–
Set User:
This is the place to choose which User profile to use for your Deskstation
