Gree KFR-35GW/NaA512, Руководство пользователя

Страница: 62 / 68

（mm） （N·m）
Φ6 15～20
Φ9.5 31～35
Φ12 50～55
2
Joint
Connection pipe nut
Fig.
Fig.
Small handle
Power connection cord
Wire clamp
Signal control wire
The list for wire connection
Wire
Blue
Brown
Yellow-green
Wire terminal
Install the connection pipe
Align the center of the piping flare with the
relevant valve.
Screw in the flare nut by hand and then tighten
the nut with spanner and torque wrench
torque wrench refer to right figure.
NOTE: Exceeding tightening torque will damage
the flare surface. Tightening torque table
Hex nut diameter Tightening torque
Wiring connection
Wiring connection for single -split type unit
Remove the handle of outdoor unit right side plate. (1pc bolt)
Remove the wire clamp, connect the power cable to the wiring terminal and fix it.
The wiring layout should be the same with indoor unit.
Assemble the handle. (fixed by 1pc screw)
Make sure that the wiring is fixed well.
To fix the power cable with wire clamp, for the cooling and heating unit,
fix the singnal control cord with wire clamp, then connect the corresponding
connector.