40
Maintenance
Service Manual
8. Install
1. Remove the rubber plug at drainage port.(As shown in
following fig)
2. Fix the drainage pipe clip on the right of rear side plate
near drainage port with a screw.(As shown in following fig)
3. Put the drainage pipe into drainage port and screw it up,
and then bind it with pipe hoop.(As shown in following fig)
4. Put the rubber plug into the other side of drainage pipe, fix
it with pipe hoop and then fix it in the drainage pipe clip.(As
shown in following fig)
Note
: install drainage pipe before using, otherwise poor
drainage will affect normal operation of the unit.
drainage port
drainage pipe clip
Clamp joint C into the inner side of window frame along the
direction of arrow.
Note
: If the inner width of window is below 28"(718mm),
please remove the adjusting plate from window frame and
then cut the window frame to make its width the same as the
width of window.
A. Installation in a double-hung sash window.
(1) Cut the sponge B to a proper length and attach it to the window
sash.
(2) Open the window; place the window frame on the window sash;
slide the adjustment plate to make the window frame close to the
window sashes at the left and right side of window; fix the window
frame on the windowsill with screws and clips of rear connection
plate. (Required quantity is shown in the sheet below)
sponge B (adhesive)
Window width (W)
Screw quantity Clip quantity
W≤28 3/11"(718mm)
2
2
28 3/11"(718mm)<W≤36 1/2"(927mm)
3
3
36 1/2"(927mm)<W≤64
"
(1625mm)
4
4
window frame
windowsill
window sash
window sash
clip of rear connection plate
Window width(W
)
joint C
window frame
inner side
window frame
cut
adjusting plate
28 3/11"(718mm
)
drainage port
drainage pipe clip
screw
drainage port
drainage pipe clip
pipe hoop
pipe hoop
rubber plug
drainage pipe
8.1 Install Drainage Pipe
8.2 Install Window Frame
