GREAT PLANES turmoil arf, Инструкция по эксплуатации

Страница: 8 / 24

❏
6. Now the elevator halves may be cut from the sheet.
❏
7. Join the elevators to the stab by snapping the clip
hinges to the joiner tube.
❏
8. Insert a Z-bend clevis (A1) into a clip hinge control
horn (C1).
❏
9. Clip the control horn onto the joiner tube aligned with
the precut slot.
❏
10. Coat the gluing area on the control horn with glue and
rotate it down into the precut slot.
A. Using a sharp #11 hobby knife, remove any flashing
from the inside of the hole you are installing the Z-bend
clevis into. Do this by rotating the blade in the hole while
applying gentle pressure. Be careful not to remove too
much material–your goal here is to remove small ridges of
flashing, not to make the hole larger.
B. Snap the Z-bend clevis into place.
HOW TO MAKE INSTALLING Z-BEND
CLEVISES EASIER
Note: You may want to protect your work surface from
excess glue. We recommend Great Planes Plan Protector
(GPMR6167) for this purpose.
A. Cut several 1-1/2" [38mm] pieces of removable
cellophane tape. Fold the last 1/4" [6mm] over to make a tab
for easy removal.
B. Lightly coat the leading edges of the elevators with
foam-safe CA–do not use an excessive amount. Hint: A
CA applicator tip is recommended to accurately control
the bead of glue.
C. Tape the tube to the leading edge of the elevators.
Weigh the assembly down on a flat surface to prevent
warping and allow the glue to harden without accelerator.
D. Once the glue has hardened, remove the tape.
HOW TO GLUE THE TUBES TO
THE CONTROL SURFACES
8