GREAT PLANES turmoil arf, Инструкция по эксплуатации

Страница: 11 / 24

❏
10. Using the 3 x 160mm [1/8" x 6-1/4"] rudder post tube
as a guide, glue four clip hinges (C2) and a clip hinge control
horn (C1) to the rudder. The control horn should protrude from
the right side of the rudder.
❏
11. Remove the rudder post tube from the rudder. Slide
two hinge retainer rings (C3) onto the bottom of the rudder
post. Align the rings with the slot in the TE of the fuselage.
Secure each ring with a drop of glue on the outside. Be
careful not to get glue between the rings.
❏
12. Glue the rudder post tube to the TE of the
vertical fuselage.
❏
13. Snap the rudder onto the rudder post.
❏
14. Glue the 3 x 150mm [1/8" x 6"] strut brace tube into
the fuselage.
❏
15. Locate eight rod supports (D2). In the following
steps note that four of the supports will be used for the main
landing gear and four of the supports will be used for the
wing struts at the trailing edge of the wing, but all of the
supports are exactly the same.
❏
16. Installing them down through the top of the wing, glue
four rod supports (D2) into the slots in both sides of the
wing. Two of the supports are at the leading edge (for the
landing gear) and two are at the trailing edge (for the wing
struts). IMPORTANT: The holes in the supports must be
angled upward and outward (matching the angle of the
landing gear and the wing struts).
IMPORTANT!!! Before gluing in any of the supports, be
certain to read the steps all the way through so you will
understand how the supports go in.
11