❏
1. Site the aircraft from behind. The stab should be
parallel to the wing. If not, use a heat gun on the fuselage
between the stab and wing to soften the fiberglass (see
photo below).
IMPORTANT!! If you get the surface too
hot, you will distort the fiberglass.
❏
2. Once the fuselage is hot, twist and hold it straight until
it is completely cool.
❏
3. Repeat this until the stab is parallel to the wing.
❏
1. Install four of the CA hinges (cut out earlier) into the
Elevator and install the elevator onto the stab.
❏
2. Deflect the elevator completely one direction and place
three to four drops of thin CA onto each hinge (not too much
or it will run down the hinge line).
❏
3. Flip the stab over and glue the other side in the
same manner.
❏
4. Install two of the CA hinges in the rudder and install
onto the fin.
❏
5. Glue the rudder hinges using the same technique as
the elevators.
❏
1. Glue the plywood servo tray doublers to the plywood
servo tray using CA.
❏
2. Trial fit the servo tray where shown. You may need to
sand the edges slightly for the best fit.
NOTE:
If you are
using tall servos, you should install the servo tray with the
doublers up to provide a little more clearance.
❏
3. Glue the tray in place using epoxy.
Note:
Rough up the
fiberglass with sandpaper and clean with isopropyl alcohol
for a good glue bond.
Install the Elevator and Rudder Servos
Install the Elevator and Rudder
A
A = A
A
Align the Tail
11
