❏
1. Install a 2 x 17mm [5/64" x 21/32"]
axle
and
axle
support (D1)
onto each landing gear leg. Make sure that
the axles are perpendicular to the centerline.
❏
2. Slide the
wheels
onto the axles, and secure them with a
wheel collar (D6)
. The flat side of the wheel collar should be
toward the wheel. Secure the wheel collar with a drop of glue
in the
teeth opposite the wheels. Align the wheels with the
centerline and secure the axles and supports with a drop of
glue through the holes in both sides of the axle supports.
❏
3. Make two wheel pants by gluing the
inner
and
outer
wheel pant parts
together. Be sure to make a
right
and a
left
. Glue the inside of both wheel pants to the wheel collars.
❏
4. Snap the
tailwheel (D5)
into the
tailwheel bracket (D4)
.
❏
5. Slide the tailwheel bracket over the rudder and rudder
post. Glue the bracket to the rudder
only
.
Do not
glue the
bracket to the rudder post.
❏
1. Remove the stock servo arms from all three of the
servos, and temporarily connect the servos and ESC to your
receiver. Power up the system and center all three servos.
❏
2. Refer to the “
Plastic Tree Parts”
listing on page 5 and
select the correct
offset double-sided servo arm
for the
aileron servo you will be using. There are three arms to
choose from:
Servo Arm A
Hitec HS-55, Hitec HS-50, Futaba 3108M
Servo Arm B
Futaba S3103, Airtronics 94091
Servo Arm C
JR 241
❏
3. Install two Z-bend clevises into the
underside of the
offset double-sided servo arm
.
Radio Setup
Finish the Landing Gear
13
Содержание FlatOut Flatana
Страница 23: ...23...
Страница 24: ...ANGLE TEMPLATES...
