GREAT PLANES FlatOut Flatana, Инструкция по эксплуатации

Страница: 16 / 24

❏
2. Without using any glue , slide the motor mount block
over the fuselage tube. Be certain the block is in the correct
position so there will be
down and right thrust. Do not glue
the motor mount block onto the fuselage tube.
❏
3. If using the included propeller, install the prop saver
onto the gearbox shaft with the large-diameter cone
forward. If using a GWS prop, install the prop saver with the
small-diameter cone forward. Tighten the screws, making
sure they engage the flat spots on the shaft.
❏
4. Slide the motor/gearbox assembly over the motor
mount block.
❏
5. Drill a 1.5mm [1/16"] pilot hole at an angle from the top
of the gearbox through the balsa block and carbon tubes.
Make sure the motor mount block does not rotate while
drilling. Secure the gearbox and block with a 2 x 8mm
[5/64" x 5/16"] wood screw.
❏
6. If using the included APC prop, insert the larger of the
two adapter rings (included in the propeller packaging) into
the rear of the propeller hub.
❏
7. Secure the prop to the prop saver with one of the
included O-rings.
❏
8. Connect your speed control to the motor and receiver.
Mount the speed control to the bottom of the right horizontal
fuselage with double-sided foam tape. Cut a small hole for the
ESC’s battery wire to cross to the right side of the fuselage.
16
GPM
APC
GWS