GREAT PLANES FlatOut Flatana, Инструкция по эксплуатации

Страница: 12 / 24

wing. Two of the supports are at the leading edge (for the
landing gear) and two are at the trailing edge (for the wing
struts).
IMPORTANT: The holes in the supports must be
angled upward and outward (matching the angle of the
landing gear and the wing struts).
❏
17. Installing them from the right side, glue two more
supports into the slots in the fuselage. Note that these first
two supports should be positioned
aft in the slots, and that
the holes in the supports should be angled downward and
outward (again, to accommodate the angles of the landing
gear and the struts).
❏
18. Glue the remaining two supports into the right side of
the fuselage. Be certain that the holes are angled correctly.
❏
19. Slide the 2 x 220mm [5/64" x 8-7/8"] landing gear legs
through the landing gear supports in the front of the wing and
fuselage. Ensure that the wing is parallel with the stab and
horizontal fuselage and perpendicular to the vertical fuselage.
Once satisfied with the alignment, secure the landing gear
legs with a drop of glue on both sides of each joint.
❏
20. Slide the 2 x 86mm [5/64" x 3-3/8"] wing struts
through both sets of supports in the back of the wing and
fuselage. Make sure that the TE of the wing is aligned with
the LE, and secure the struts with a drop of glue on both
sides of each joint.
❏
21. Snap the ailerons onto the wing TE.
❏
22. Using an Easy-Touch bar sander with 220-grit
sandpaper, sand a bevel into the edges of the fuselage
diagonal reinforcements at a 45° angle toward the inside.
Glue the
diagonal fuselage reinforcements into position
where shown. Align the lower edges with the edges of the
horizontal fuselage halves. Be careful not to twist the
fuselage as you glue the parts down.
12