❏
1. Cut the wing and ailerons from the foam sheet.
❏
2. Insert
offset Z-bend clevises (A2)
into opposing
sides of two clip hinge control horns. Following the
Expert
Tip
previously described, use the 3 x 914mm [1/8" x 36"]
wing trailing edge tube
as a guide to glue four hinges and
a control horn into each aileron. The control horns should
protrude from the bottom of the ailerons (red and white
side), and the offset Z-bend clevises should be on the
inboard sides of the horns. Remove the tube once the CA
has hardened.
❏
3. Glue a
control surface brace (E1)
onto the roots of
the ailerons.
❏
4. Slide four hinge retainer rings (C3) onto the wing
trailing edge tube. Position the rings so that they align with
the inner slots in the TE of the wing. Secure each retainer
with a drop of glue on the outside of the gap. Glue the
trailing edge tube to the TE of the wing. Be careful not to get
glue between the rings.
❏
5. Glue the 3 x 915mm [1/8" x 36"]
wing leading edge
tube
to the LE of the wing.
❏
1. Cut the
upper
and
lower vertical fuselage halves
and the
right
and
left horizontal fuselage halves
free from
Assemble the Fuselage
Assemble the Wing
9
Содержание FlatOut Flatana
Страница 23: ...23...
Страница 24: ...ANGLE TEMPLATES...
