GREAT PLAINS Ultra-Till I 3030 Series, Руководство оператора

Страница: 26 / 36

Great Plains | 576-026M-A | 05/11/2021 Table of Contents Index 24
UT3030-UT5052 Table of Contents Index Maintenance and Lubrication
Maintenance and Lubrication
Maintenance
1. Always use the transport lock when working on or doing
maintenance to the Discovator. If folded, be sure your
wing stop pins are in place. Read and understand all safety
decals on your equipment.
2. During the first season of operation, and periodically after
that, check your bolts for tightness. Check shank pivot
bolts for tightness. Check shank pivot bolts on the spring-
loaded shank, these must remain tight to prevent
excessive wear on the shank assembly.
3. Replace or rotate worn parts as needed -- hinge bolts,
clevis pins, bearings, sweeps, shanks, etc. Boron disc
blades cannot be rolled to be sharpened, they must be
ground. Cracks and breakage will occur if rolled.
4. Check and tighten or replace any hydraulic leaks. Check
hoses for any leaks. It is important that there are no leaks
on the equipment.
5. Grease wheel bearings and walking beams sparingly. Over
greasing may cause damage to seals and reduce the life of
the bearing. Grease hinge points periodically. Reel and
Disc or Coulter Gang bearings are maintenance free and
do not require greasing.
6. Check drag bolts for loosness or excessive wear. Replace
broken or bent teeth. Your drag is an important part of the
tillage operation.
7. If machine is stored outdoors over the winter months, it is
a good idea to fold the machine then set it down on the
ground so all the cylinders are retracted to protect the
cylinder rods. This will extend the life of the cylinder
seals and reduce internal and external leaks.
By following and maintaining a routine service and
lubrication program, your tillage equipment will give you
many years of service.
For the most current manual information, visit Great
Plains website listed below. For more information on
operating, adjusting or maintaining your Great
Plains Discovator, assistance is available. Contact:
Great Plains Service Department
1525 E. North St.
P.O. Box 5060
Salina, KS 67402-5060
Or go to www.greatplainsag.com and follow the contact
information at the bottom of your screen for our service
department.
Lubrication
Wheel Bearing Hub
1 zerk on each hub;
4 total
Type of Lubrication: Grease
Quantity: Sparingly, Do Not Over Grease, may cause damage
seal.
Repack wheel bearings annually or every 2500 acres.
50
50
Multipurpose
spray lube
Multipurpose
grease lube
Multipurpose
oil lube
Intervals (service hours)
at which lubrication is
required
41622