7
Hardware for Step 8:
8x
#8 Split Washers
8x
#4 45mm Bolts
8x
#7 Washers
Assembly:
Desk with Drawer
STEP 7:
Take the desk top (A) and lay it upside-down on a
clean, dry and smooth surface.
Attach the flat runners (#9) to the inside drawer
holding supports on the underside of the desk top
as shown, using 2 x 15mm screws for each runner
(see hole guide above).
Please note:
The wheel of the drawer runners
should be at the front of the desk top, next to the
opening where the drawer will be inserted.
STEP 8:
The legs of the desk can now be attached. Take each
45mm bolt (#4) and thread on a split washer (#8)
first followed by a flat washer (#7). Use 2 x bolts and
washer sets for each leg (B).
Please note:
When screwing in the pairs of bolts,
for smoother insertion do not screw one individual
bolt all the way in, but instead alternate securing each
of the bolts until they are completely secure and as
tight as they can possibly go.
Hardware for Step 7:
2x
#9 Flat Runners
4x
#6 15mm Screws
screw 16mmL
A
B
#6
#9
#7
#8
#4
FRONT
BACK
BACK
FRONT
HOLE GUIDE
