10. Using the charger for the first time
40
Charge output 1
Charge Output 2
Power
On
<INPUT POWER SETTING>
VOLTAGE : 12.0V
CURRENT : 20.0A
1OUTPUT RATE: 50%
2OUTPUT RATE: 50%
ESC
Channel
Version 1.00
< USER NAME... >
ULTRA DUO-----
------ PLUS 80
11] LiPo 3S 2200mAh
STORE MODE START
CHG.
:
2
.
1A
4.20V/C
DCHG. : 10.0A 3.0V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
11] LiPo 3S 2200mAh
STORE MODE START
CHG.
:
2
.
1A
4.20V/C
DCHG. : 10.0A 3.0V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
Connect
power supply
Connect the ULTRA DUO PLUS 80 to a suitable 12 - 28 V DC mains PSU (min. 25 A) using the G4 connectors, or to a
suitable car battery using the terminal clips also supplied in the set. Take care to observe correct polarity: connect the
black plug to the negative (-) terminal, the red plug to the positive (+) terminal. The charger features reverse polarity
protection: if you connect it incorrectly, it simply doesn‘t work. Reversed polarity will not immediately ruin the charger;
simply disconnect it, then re-connect it “the right way round”.
When plugged in correctly, the charger’s welcome display appears; you will also see the firmware version of the charger
together with the user’s name, if you have entered one (see also Chapter 11).
After a few seconds the INPUT POWER SETTING screen appears, where you can set the input voltage (VOLTAGE)
and input current (CURRENT) of the mains PSU you are using, as well as the way the charge power (OUTPUT RATE)
is shared out between the two outputs.
These settings are very important - especially if the input voltage is less
than 16 V - to ensure that the ULTRA DUO PLUS 80 can exploit its maximum charge power without overloading
the PSU.
The Line Select arrow on the left-hand side always shows the currently active line; you can move between the lines
using the INC or DEC button. Pressing the ENTER button selects the parameter (highlighted on the screen), which
can then be adjusted using the INC or DEC button. Pressing ENTER again adopts the new value, and the highlight
disappears.
Once everything is set correctly, press the ESC button to move to the main screen display, which is divided into two
halves: the top half shows the parameters for charge output 1, the lower half those for charge output 2. The active
charge output (i.e. the one which can be programmed) is displayed normally, while the inactive output is highlighted
(black background). You can switch between the outputs using the
CHANNEL button.
Operating Manual ULTRA DUO PLUS 80
[ LANGUAGE SELECT ]
1. ENGLISH
2. DEUTSCH
3. FRENCH
ENTER
Language select
Press and hold the
ENTER button
while you switch
on the power
supply
.
Power
ON
ENTER
INC
DEC
Language select
