GRAUPNER Theodor Heuss, Инструкция по эксплуатации

Страница: 24 / 40

24
English
Troubleshooting Guide
Problem possible error Actions
Motor will not start Motor cable unplugged / demolished Plug in cable / new solder
Drive battery empty Changing the battery or charging
Remote control does not work correctly,
incorrectly adjusted throttle trim
Check remote control, adjust trim
correctly
Defective motor Replace the motor
Throttle set incorrectly Set trim to neutral
Motor runs in reverse Servo reverse switch throttle displaced Bring servo reverse switch into
the correct position
Engine has no power Drive battery is almost empty Changing the battery or charging
Throttle set incorrectly Set trim to neutral
Drive is running hard Check drive, clean and grease
the shaft
Drive is very loud Check shaft and motor
Motor gets very hot Allow engine to cool, check en-
gine, install water cooling, clean
and grease the shaft
Model is difficult to
control
Transmitter battery empty Change batteries or recharge
batteries
Displaced steering trim Check and adjust steering trim
Interference Take a short break and then re-try
Throttle set incorrectly Set trim to neutral
Model has no
function
Transmitter and receiver are not bound Transmitter and receiver rebind
(manual of the transmitter)
Interference Take a short break and then re-try
Displaced throttle trim Set trim to neutral
LEDs on the transmitter does not light up Check that the model and trans-
mitter are turned on. Check for
empty batteries
Model is very noisy Propeller was damaged Replace the propeller
Shaft is dirty or difficult to move Clean the shaft and regrease
Screws are loose Check the placement of all
screws and tighten.
Components have dissolved Check all components and attach
them again
Graupner/SJ THEODOR HEUSS