23
English
23
23
Daughter boat
Open the central hatch (the one with the integral mushroom-shaped funnel) on the boat; it is only held in place by double-
sided adhesive tape. For maintenance purposes the two entry hatches can also be removed completely; these are also secu-
red with double-sided tape. When subsequently running the boat, please ensure that the tape still has adequate adhesion. If
you are not sure, replace it using the type of double-sided tape intended for sticking photos in photograph albums.
Solder a BEC connector to the motor wires, taking particular care to ensure that the motor shaft spins in the correct direction.
When you connect the battery, the propeller must rotate in such a way that the boat would move forward. Wrap insulating
tape round the soldered joints at the battery terminals; it is essential that they cannot make electrical contact with each other.
Fix the speed controller and the receiver inside the hull using Velcro tape. Deploy the receiver aerial inside the hull in a
similar manner to the cruiser. The battery should be installed below the rear cockpit, and secured in that position with Velcro
tape.
Recommended accessories (cruiser)
Best.-Nr.
Bezeichnung
33016
MC-16 Computer system Graupner HoTT
2875
Speed regulator, NAVY V40R (for the center motor)
2875
Speed regulator, NAVY V40R (for the outer motors)
3936.11
Servo V-cable
2591
Lead battery, 12 V/7 Ah
2989
G2 connector system for connecting speed regulators (3 required)
3068
G2 distribution cable
3597
Faston connectors, 4.8 mm, P10
3389
Highly flexible stranded copper wire
Recommended accessories (daughter boat)
33506
GR-12 HoTT receiver
2861
Navy V15R regulator
90152.9
LiPo battery, 7.4 V, 1300 mAh
Maiden voyage
Charge the batteries and test the functions of the model. Secure all coverage so that they can not fall, so that no water can
penetrate into the model. Now you can maiden voyage.
Slow start during its maiden voyage, you do get familiar with the handling characteristics of the model. Test the steering,
braking distance, and range.
If the model begins „bounce“ to change the position of the drive until the model runs clean again, or move the batteries
forward.
Have fun with your model THEODOR HEUSS No.: 2013
Graupner/SJ THEODOR HEUSS
to receiver
Speed controller
Drive battery
Motor
BEC connector
BEC connector
Drive battery
Speed controller
Receiver
1
3
4
6
Speed controller
Rudder servo
Содержание Theodor Heuss
Страница 13: ...13 13 Notizen Graupner SJ THEODOR HEUSS...
Страница 25: ...25 English 25 25 Notes Graupner SJ THEODOR HEUSS...
Страница 37: ...Remarques 37 Fran ais Graupner SJ THEODOR HEUSS...