GRAUPNER Skalar, Руководство пользователя

Страница: 35 / 59

elektro
Skalar
35
10. Cabin
(bag SKR-6)
10.1 Installing the front cabin support system
Fix the two cabin stand-off pillars to the brackets at the front of the sub-structure by fitting M3 x
12 socket-head cap screws from the rear.
10.2 Attaching the cabin
Press two rubber grommets 3515.3 into the holes in the former 4475.17, and secure them with a
drop of cyano on one side. Push the former onto the pillars mounted at the front of the
mechanics, with the curved side at the bottom, and check that the pillars engage completely in
the rubber grommets.
Press two rubber grommets in the 7 mm Ø holes in the cabin. Slip the cabin over the mechanics
from the front, and engage the two stand-off pillars at the top in the rubber grommets in the
cabin.
Raise the cabin at the front until the former attached to the mechanics makes contact with the
bottom of the cabin moulding.
Glue the former to the cabin in this position using Stabilit express. Allow the adhesive to cure
completely, then remove the cabin as follows: first ease it off the rear stand-off pillars at both
sides, and then slide it forward; it should come off easily. It should be just as easy to re-fit it by
reversing the procedure.
Run the receiver aerial along the mechanics to a point aft of the front skid bar, so that the cabin
can easily be lifted off without snagging the aerial. Fit the plastic guide tube for the aerial through
the two loops on the inside of the skid bars, and fit small pieces of fuel tubing on it to prevent it
slipping out of the sleeve. The flexible aerial wire can then be run along the skid bar, slipped into
the guide tube from the front, and allowed to trail out of the tube at the rear.