GRAUPNER Skalar, Руководство пользователя

Страница: 20 / 59

elektro
Skalar
20
Connect the swashplate servos to the swashplate using the previously prepared pushrods to
produce a 120° linkage.
2.2 Installing the remaining radio control system components
To attach the gyro inside the RC box we suggest using double-sided foam tape, e.g. Order No.
742. If you install the gyro in another place, be sure not to run the cables from the gyro to the
receiver close to the motor or the controller. Run the cables forward to the receiver, together
with the servo leads, along the side of the mechanics.
Pack the receiver battery and receiver in foam rubber and stow them in the RC box. Install the
motor controller close to the motor on the lower strut of the leftside upper part frame using
double-sided foam tape and cable ties to secure it.
Wrap the leads with spiral tubing and fix them to the mechanics using cable ties. The cables
must not be under tension or strain, must not be able to touch any moving or rotating parts, and
must not be in danger of chafing on any sharp edges.
The receiving system switch is intended to be mounted in the switch bracket attached to the
right-hand side of the upper partial chassis. Connect it to the receiver and the receiver battery.
If you install the switch console as described, the RC switch will be easily accessible even when
the canopy is in place. If you intend installing the mechanics in a different fuselage, you may
prefer to install the switch console in an alternative position, as already described: swivel it up-
wards through 90° around the front attachment point.
The switch plate can now be fixed to the partial chassis without the tubular spacers, since the
switch itself rests within the machined opening in the partial chassis.