GRAUPNER Skalar, Руководство пользователя

Страница: 16 / 59

elektro
Skalar
16
1.7 Attaching the mechanics to the sub-structure
Offer up the circular spigots on the main gearbox (from Stage 1.5) to the sub-structure side
frames at the rear, and allow them to snap into place. Fix the parts together using M3 x 16
socket-head cap screws and washers.
Two further M3 x 16 socket-head cap screws are used in the centre; fit a washer on each one
first. Fit the brass sleeves 4450.34A in the sub-structure side frames, and fit the screws through
them and the upper part-frames with the on-glued spacers into the mechanics side frames.
Tighten the screws in this position.
Undo the two M3 x 16 socket-head cap screws at top front which were fitted into the spacer
4475.27 when the motor was installed, then fit the upper part-frames 4475.101 and the spacer
sleeves 4450.34A and tighten the screws fully again. Fix the rear end of the partial chassis hal-
ves to the lower attachment points of the front (unused) servo aperture in the mechanics side
frames, in each case using two 2.2 x 13 mm self-tapping screws.