GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
#0059939
04/2008
16
This is accomplished by laying the bottom section of the boat on a flat surface, sponsons down, and
placing a weight inside the hull to keep it in this position.
The six steps of the sponsons must be left resting squarely on a flat surface until the glue has set
hard!
•
Tack the horizontal crutch
(part 6) to the ABS strips
(parts 2) using cyano.
•
When the glue has set
hard, apply Stabilit
Express or Acrylit to the
full length of the joint
between the crutch and
the sides of the bottom
hull section.
•
The sponson former (part
4) only needs to be spot-
glued to the hull floor.
•
Assemble the servo
mount from parts 7 and 8,
and glue it in the slots in
the transom
reinforcement and the
hull floor.
Important
•
Leave the boat weighted down on the flat surface while you check that the upper hull section fits
accurately.
•
The first step is to apply Stabilit Express to the
front area of the top and bottom hull sections
, then
place the top section on the bottom shell and position it accurately.
Glue here
Press crutch down
Insert
Glue with Stabilit Express
