GRAUPNER POLARON EX-1400, Руководство по эксплуатации

Страница: 38 / 56

Eng
lish
38 39
PM
06:49:16
CH1 CH2
SERVO
700 2300 1500
0.3s 1500
RPM:
0.00
V
0
KV
0
OK
700 2300
1500
1100 1900
Turn afterwards continuously by hand the shaft of the motor for about 5 sec-
onds. Once the sensor is detected and is fine too, appears OK on the left of
the screen instead of the four points. Now you can check the functionality of
your controller / motor combination as needed using the servo test function.
In order to check the motor speed and power, as shown in the figure below,
you need the optional splitter, Order Nr. S8002 grind between motor, controller
and charger.
ORANGE
YELLOW
BLUE
EX-1400
Submenu “MOTOR“
PM
02:19:42
CH1 CH2
MOTOR
1. BREAK-IN
2. PROGRAM
3. MOTOR TEST
In this sub-menu “MOTOR” you can choose by simply tapping the correspond-
ing icons as break-in program, a motor test program with max. four possible
combinations of voltage and duration as well as a motor test program, in all
three parts of the program the charger acquires both the power supply as well
as the power control of the connected brushed motor.
Display “Break-in“
Connect your brushed motor directly to output CH1 or CH2 and select the appropriate channel
from the display.
After opening the submenu “BREAK-IN” pull down in the lines “time” and “voltage” you may deem
suitable values. Pressing the ENTER button under the display it starts the break-in process of your
brushed motor and the starting of the motor is soft.