GRAUPNER MICRO MAGIC, Руководство пользователя

Страница: 9 / 18

Assembly of the Foresail (Fock)
Pull the counterweight from the jib boom. Insert the pin through the ring at the lower end of
the forestay (the tack) and insert the pin again. If the pin is quite loose, secure it with a drop
of glue.
Run the battered already on tack downhaul as shown from front to back through the eyelet of
the plastic part on the jib boom and tie it close with the clip at the luff.
Attach the clew as did in the mainsail between the silicone hose pieces at the boom yardarm.
Knot a piece of cord with deferred clam-
ping slide to the ring which is struck about
10 cm below the masthead. The two to-
gether lying holes of the clip pusher
should be placed down (as in the arrange-
ment backstay). Run the lower end of the
cord through the ring on foresail head and
back and through the bottom hole in the
clamping slide. Clamp the cord firmly as
provisionally with a clothespin.
Move the ailing ring to the jib boom so
that it is above the front hooks on deck
when the boom yardarm is still about 10
mm from the mast. Hang the ring at the
prepared bowstringer in the rear hooks on
deck. Position the clamping slide approxi-
mately in the middle of the hooks. Run the
free end of the string through the last
existing ring, hang this ring a in the front
hook and knot the cord up to the ring on
the jib boom. The jib boom should have
no more than 10 mm from the hook, so do
not be attached too high on deck.