GRAUPNER m-12 HOTT, Руководство по эксплуатации

Страница: 70 / 77

It is used to program the sensors related with voice function. The default article
REPEAT, TRIG, VARIO, TRANSSMITTER, RECEIVER are available and the optional
sensors could be attached. If the optional sensor is connected, it is need to add the
function for the optional sensor at SENSOR SELECT mode then VOICE TRIGGER
article is created. The useable sensors are GENERAL MODULE, ELECTRIC AIR MOD-
ULE, VARIO MODULE, GPS, AIR ESC.
- REPEAT
You may set the time and switch and if the switch is on, one of voice functions is
repeated for the setting time. Press DOWN buttons to go to VOICE TRIGGER line and
press ENT button then the default value 10sec on REPEAT is highlighted. Press UP/
DOWN buttons to set the desired value and press ENT button to remove the highlight.
Press the direction button to highlight the hyphen mark then press ENT button. The
popup message “push desired switch into position on” is appeared. Operate the switch
to be used as REPEAT on/off, that switch is designated as REPEAT on/off. After all
process, REPEAT function is operated when the switch is on.
19. VOICE TRIGGER
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
It shows RF status between transmitter and receiver through telemetry function.
Press DOWN button to go to RF STATUS VIEW line and press ENT button to access to RF
STATUS VIEW mode. You may check RF status at this screen.
ENT
ESC
TEL VIW
18. RF STATUS VIEW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
ENT
ESC
TEL VIW
press
press
press
press
70