Parameter
Display page
Description
Setup
Warning Time
Page 2 – page 24
Warning time
OFF, 5, 10, 15, 20,
25, 30 sec.
Repeat Time
Page 2 – page 24
Repeat time
Always, 1, 2, 3, 4, 5
Minuten, One Time
Signal Tone
Page 2 – page 24
Signal tone
A - Z
Save Sensor
Page 1
saves the setup to the General
Engine-Module
OK / NO
Factory Set
Page 1
Reset to factory settings
OK / NO
If you wish to carry out an adjustment (point 6.1 to 6.15) you must use the INC (
) or DEC (
) buttons
above the screen to select „page 1 - Save Sensor“. Simultaneously pressing the INC and DEC buttons
(
SET
) switches the parameter to be adjusted to inverse video (white on black); this indicates that it can be
programmed: pressing the INC (
) button at this point increases the value to YES. When the adjustment is
complete, save the selected setting by pressing the INC and DEC buttons (
SET
) simultaneously; the dark
background now disappears in order to con
fi
rm this action.
If you do not want to save the adjustments, select NO.
Warning:
• Do not carry out any programming work on the sensors while the model is
fl
ying, otherwise there is a real
risk that your model will
fl
y out of control while you are not concentrating on it!
• If your model is
fi
tted with two or more receivers, it is absolutely essential that you do not carry out pro-
gramming work during a
fl
ight, as this can alter the settings in the receivers to which no telemetry equip-
ment is connected; in the worst case this could result in the model crashing.
For this reason always carry out programming on the ground, and check that only the receiver with con-
nected sensors is powered on.
07
33610 General Engine-Module - Graupner HoTT 2.4
