GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
4
Order no. 3935.65 For connection to the receiver
2 units
Order No. 1587-20 Hook-and-loop cable tie
1 package
As a receiver battery, we recommend a two-cell LiPo battery with a capacity of at
least 5 Ah, e.g. Order no. 99013, which must always be well-maintained before and
after flight.
Rechargeable batteries are recommended for the receiver and transmitter, because
they offer the greatest safety.
See the FS catalog for the corresponding charger.
Foam rubber for the bearing of the receiver
Hook and loop tape Order no. 3368.1 for the fastening of the receiver
Hook-and-loop cable tie Order no. 1587 for the fastening of the drive battery
Required accessories
Retractable landing gear
Order no. 1137
Cockpit equipment
Order no. 1055.1
Joystick set
Order no. 1064.2
Assembly of the ASH 31 MI
Only the assembly of the electric version is described in the assembly manual.
Obviously the work pertaining to the extend/retract drive is omitted for the glider
version.
Only begin with the assembly once you are familiar with the components and
individual building stages. If there are grounds for objection of a component, inform
your specialist dealer prior to beginning with the construction.
The hull
All parts of the hull to be adhered must be sanded with sandpaper until the area to be
adhered becomes matte (also refer to the information in the adhesives table).
Remove the pull-away material on the adhesion areas of the hinge joints for the
closing flaps of the landing gear and extend/retract drive. Attach the hinges at the
flaps and hull as shown in the photos. In the process, make sure that the gap
between the hull and flaps is the same size all the way around.
After the adhesive hardens, it should
adhered with a strip of glass fabric leaving a slight protrusion for the hinged joints.
Torsional springs must be bent from the accompanying Ø 0.6 mm steel wire to close
the flaps and must be adhered as shown in the photo.
