GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
13
To secure the outer wing to the inner wing, engage the plastic locking devices in the
corresponding holes.
After the adhesive hardens, the multi-lock studs are adhered in the outer wing
sections. For this purpose, adhere Tesafilm over the area around the two eyes in the
wing center section and cut the film crosswise over the eyes. Now insert both studs in
the eyes. The outer wing sections are also protected with Tesafilm in the area around
the holes for the studs and are also opened. The holes in the outer wings are filled
with a somewhat hardened resin and the plastic part is pushed in until the edge ends
flush with the root rib. After the hardening of the adhesive, fit the counterpiece in the
hole in the inner wing, apply adhesive and press the two wing parts together flushly
with the CFRP connector and the torsion pins, then fix in place with adhesive tape
until the adhesive hardens. After the adhesive hardens, the excess resin can be
removed together with the adhesive tape.
The winglets are then each inserted on the outer wing with two Ø 3mm and Ø 2mm
steel pins. The winglets are secured with strips of adhesive tape.
