GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
Id.-Nr. 0058032 01/2008 19
The kit is highly pre-fabricated. Nevertheless, the procedures described in these instructions should be
carried out with the greatest care in order to ensure that the model flies safely and successfully.
Electric power system and accessories
Power
Motor
Folding propeller
Flight battery
Speed
controller
variant
Order No.
Order No.
Order No.
Order No.
Sport
COMPACT 460 Z
CAM FOLDING
GRAUPNER LiPo
BRUSHLESS
11.1 V
PROP
3/2100, 11.1 V / 2.1 Ah
CONTROL
45BEC
7748
1335.30.15
plus
7643.3
7235
taper collet
6062.2
High-
COMPACT 540
CAM FOLDING
GRAUPNER LiPo
GRAUPNER
performance
14.4 V
PROP
4/4300, 14.8 V / 4.3 Ah
GENIUS 40
7721
1335.30.15
7656.4
2896.G35
It is important to obtain all the accessories required for your selected power variant before you start
construction, as the components will need to be trial-fitted and installed at the appropriate stage.
RC system and accessories
This model should only be flown with an FM radio control system with six or more channels, e.g. the
mx-12 to mc-24 RC sets. For more information about radio control system accessories please refer to
the main FS catalogue, or the operating instructions supplied with your radio control system.
You will need the following additional components in order to operate the model:
4
C 3341 ECO wing-mounting servo
Order No. 5120
1
Servo extension lead, 320 mm
Order No. 3935.32
2
Servo suppressor filter
Order No. 1040
1
R700 receiver
Order No. 3551
1
Receiver crystal
Order No. 3265…
Building the model
Use UHU plus schnellfest (fast-setting epoxy), Order No. 962, as adhesive throughout the construction
of this model, unless specifically stated otherwise in the building instructions.
Thoroughly sand all areas inside the fuselage where parts are to be glued.
Allow plenty of time for glued joints to set hard. The glue must be completely cured before you resume
construction.
Building instructions
Cut a slot 3.2 x 15 mm in size for the outer sleeve of the rudder “snake” (18), and check that the fin (9)
is an easy sliding fit in the opening in the tail end of the fuselage; ease the slot if necessary. Glue the
plywood nut support (5) to the underside of the tailplane mount on the fuselage (4).
