GRASS ZPM, Руководство по эксплуатации

Страница: 27 / 48

7-004 Changing to Another Drawer Width Illustration 7-006-01
After the drawer width is set according to Section 7-003, the drawer width can be changed without tools.
Pull the index pin „1“. Move the unit carrier „2“ to another index stop „3“. Release the index pin „1“ so that it en-
gages in the index stop „3“.
It is beneficial for the machine operators if the drawer widths are written on the machine frame; especially, if the-
re are a lot of index stops on the Zargen press.
7-005 Changing to Another Zargen slide height Illustration 7-006-01
Such a change is possible only with the low Zargen 6035.
- Disconnect the ZPM from the pneumatic air line supply.
- Pull down both compression slides „4“.
- Twist the set collar „5“ on the piston rod „6“ of both insertion cylinders until the Allen screw „7“ points upward.
- Reconnect the pneumatic air line supply.
Warning: Both compression slides will then move upward!
7-006 Changing to another Zargen slide length Illustration 7-006-01
Changing to another Zargen slide length does not require tools.
- Open both toggle levers.
- Take down the left and right change-over inserts by pulling upward.
- Attach the new left and right change-over inserts.
- Screw down the left and right back wall - compression die fence „10“ with a star screw „9“.
- Mount both back wall dowel - compression die fence „10“ on the respective new positions.
7-007 Setting the Back Wall Height Stops Illustration 7-007-01
There are 3 possible various back wall heights for each change-over insert. If more than 3 back wall heights
are needed, then additional back wall height stops can be mounted.
(Loosen the flap screw „7“ on the back wall height stops „8“. Twist out the bumper bar „2“ counterclockwise.
Attach the additional back wall height stops. Twist in the bumper bar „2“ until it is securely fixed.)
The stop pins „1“ of the back wall height stops can be moved in a vertical direction. With unnecessary back wall
height stops, the stop pins are simply pressed down. When needed, these can be pressed back up without any
problem.
- Move the unit carriers to the front of the respective drawer width.
- Open both toggle levers.
- Place a front panel on both front supports ( with the front bore holes up).
- Place a drawer bottom „3“ (with the bottom groove towards the machine operator).
- Place a drawer back wall „4“ on the back wall support „5“ (with the dowel bore holes up).
- Place a straight piece „6“ on the drawer bottom.
- Slide the drawer back wall „4“ against the component piece „6“.
- Loosen the flap screw „7“. Slide the back wall height stop „8“ against the back wall „4“. Tighten the flap
screw „7“. Repeat on the second side of the Zargen press.
7. OPERATING THE ZPM
The star in your cabinet
27