GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию, Страница: 33 / 138

33
KMV-3901/KMV-3911
Installation & Service Manual
Setting a Densité CPU-ETH2 Controller’s IP Address
To set the Densité controller’s IP address
1 On the KMV-3901/3911 frame’s local control panel, press the CONTROLLER button.
See
Using the Densité Frame Control Panel , on page 27 .
2 Press the [–] button repeatedly until ETH1 OPTIONS appears on the display, and then
press the SEL button.
3 Press the [–] button repeatedly until IP ADDRESS appears on the display.
4 Press the SEL button.
The current value appears on the display.
• Press the [+] and [–] buttons, to change the digit at the current input position.
• Press SEL to move one position to the right.
• Press ESC to move one position to the left.
5 When the display shows the desired value, press SEL repeatedly until you reach the last
position (if needed), and then press SEL once more to save your changes and return to
the previous menu level.
IP ADDRESS appears on the control panel’s display.
6 Press the [–] button.
NETWORK MASK appears on the control panel’s display.
7 Repeat step 4 and step 5 to configure the netmask.
8 Once you have set the network mask, press the [–] button again.
GATEWAY appears on the control panel’s display.
9 Repeat step 4 and step 5 to configure the gateway.
10 Once you have set the gateway, press the CONTROLLER button to exit the controller’s
menu.
The Densité controller restarts.
Note:
Pressing ESC when the input focus is in the first position returns to
the previous menu level. Pressing SEL when the input focus is in the last
position saves the changes and returns to the previous menu level.
IMPORTANT
Make sure the controller’s internal clock is set to the correct date and
time.
To set the date and time, see Setting the Multiviewer’s Time and Date , on
page 34.