2. Setup : How to Make the Settings
12
Make the settings required for data capture. Here we will make only those settings
that are minimum requirement. The other settings will be not changed from the
factory default settings.
Points to Remember
Basic Setup Menu Operation
•
Examples of selection menu operations (AMP screen)
(* Select "DC" for voltage measurement, and "TEMP" for temperature measurement.)
The , [ENTER], and [QUIT] keys are used to set the condition on the setup menu.
The current position of the cursor on the setup menu is displayed in green.
Use the keys to move the cursor. If you press the [ENTER] key at the cursor
position, a selection menu, a numerical input menu or a box of entering value for selected
item is displayed.
If you press the [QUIT] key, the screen closes and the settings are canceled.
1. Use the keys to move
the cursor to the Input
parameter of CH 1 and then
press the [ENTER] key.
2. A select box is displayed when
the [ENTER] key is pressed. Use
the and keys to select.
3. Press the [ENTER] key to
confirm your selection.
Select with ,
and [ENTER] key.
1. Press the [MENU] key to display the setup menu screen.
3. Select "Off" for the channels other than CH1 and CH2.
2. Set Input to "TEMP" and Sensor to "TC-T" for CH1,
and set Input to "DC" and Range to "1V" for CH2.
(1) Move the cursor to CH1 "Sensor" and select "TC-T" and then move it to
"Range" and select “100°C” .
(1) Using the procedure described above, select "Off" for CH3 to CH10.
Use the [CH GROUP] key to switch to the CH11 to CH20 group.
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and
then move it to "Range" and select "1V."
