CHAPTER 3. CRAFT ROBO CONTROLLER
3.6 Messages
The USB port is currently in use. Please wait ten seconds, and then try again.
Cannot communicate with the Craft ROBO. Check that the USB cable is connected
correctly, press the Craft ROBO's standby switch, and then confirm that the LED is lit.
Craft ROBO communication error. Press the standby switch twice.
→
Follow the instructions in the message.
GITKUSBP.DLL could not be found, and so the Craft ROBO Controller could not be
started. Please reboot your computer or re-install the Craft ROBO Controller.
The GITKUSBP.DLL functions could not be found, and so the Craft ROBO Controller
could not be started. Please reboot your computer or re-install the Craft ROBO
Controller.
→
Follow the instructions in the message.
To install the software again, first uninstall the Craft ROBO Controller currently installed.
If the problem is not solved, download the latest version of the Craft ROBO Controller
from the Craft ROBO website and install it.
The value specified for the horizontal distance between the registration marks exceeds
the specifiable range.
Please specify a distance in the range 0 to 970.0 mm.
→
Follow the instructions in the message.
Registration mark reading failure. Please reload the medium.
→
Registration mark reading failed.
Turn off the standby switch of the Craft ROBO, reset the media and turn the standby
switch on again.
The Craft ROBO Controller is already active. Please shut the controller down and perform
the operation once again.
→
This message is displayed when you duplicate starting up the Craft ROBO Controller.
Exit the currently operating Craft ROBO Controller and restart it to continue operation.
.
3-23
Содержание Craft ROBO CC100
Страница 1: ...User s Manual MANUAL NO CC100m UM 152...