P a g e
|
59
GVC3210 Administration Guide
Version 1.0.1.21
802.1x Identity
It is used to fill in the identity information for the selected 802.1x mode. This setting
will be displayed only if 802.1x mode is enabled.
802.1x Secret
It is used to enter the secret for the 802.1x mode. This setting will be displayed only if
the 802.1x mode is
set to “EAP-MD5” or “EAP-PEAP”.
Private Key
It is used to enter the private key password for the 802.1x mode. This setting will be
displayed only if the 802.1x mode is
set to “EAP-TLS”.
CA Certificate
(Upload)
It is used to upload the CA Certificate file to the device. This setting will be displayed
only if the 802.1x mode is
set to “EAP-TLS” or “EAP-PEAP”.
Client Certificate
(Upload)
It is used to load the Client Certificate file to the device. This setting will be displayed
only if
the 802.1x TLS mode is set to “EAP-TLS”.
Private Key
(Upload)
It is used to load the Private Key file to the device. This setting will be displayed only
if
the 802.1x TLS mode is set to “EAP-TLS”.
QoS
Enable LLDP
It is used to enable the LLDP (Link Layer Discovery Protocol) feature on the device. If
it is set to “Yes”, the device will broadcast LLDP PDU to advertise its identity and
capabilities and receive same from a physical adjacent layer 2 peer. The default
setting is "Yes".
Layer 3 QoS for
SIP
It is used to define the Layer 3 packet’s QoS parameter for SIP messages in decimal
pattern. This value is used for IP Precedence, Diff-Serv or MPLS. Default setting is
26.
Layer 3 QoS for
Audio
It is used to define the Layer 3 packet’s QoS parameter for RTP messages in decimal
pattern. This value is used for IP Precedence, Diff-Serv or MPLS. Default is 46.
Layer 3 QoS for
Video
It is used to define the Layer 3 packet’s QoS parameters for H.264 messages in
decimal pattern. This value is used for IP Precedence, Diff-Serv or MPLS. Default
setting is 34.
Layer 2 QoS
802.1q/VLAN Tag
It is used to define the VLAN Identifier of the Layer 2 frames. The default value 0 which
means the frame does not belong to any VLAN.
Note:
Please do not change the setting before understanding the VLAN's settings.
Otherwise the device can't get the correct IP address.
Layer 2 QoS
802.1p Priority
It is used to define the Priority Code Point within a Layer 2 frame header. The valid
range from 0 to 7. The Default value is 0 which is equivalent to the Routine class for
the Class of Service.
Proxy
HTTP/HTTPS
Proxy Hostname
It is used to configure the HTTP/HTTPS proxy URI of the network. Some of networks
require going through a proxy to access to the Internet. The default setting is keeping
this field blank.
HTTP/HTTPS
Proxy Port
It is used to configure the HTTP/HTTPS proxy port number of the network. Some of
networks require going through a proxy to access to the Internet. The default setting
is keeping this field blank.
