Model
Company name
Net weight and volume
of the packaging
Inspector's signature
Power supply voltage
and frequency
Serial number
Gross weight and di-
mensions
Signature confirming
quality checks per-
formed
Figure 7 Identification plate
located on the appliance
packaging.
Attention!
•
Do not power the appliances with voltages and frequencies
outside of the values stated.
•
Check that the electric power supply data correspond with
the electric energy supply values.
•
Remove the upper panel by loosening the two rear M6 torx head screws and the two upper M6 hex-
head screws. Once you have removed these four screws, slide the panel towards the back of the
appliance and remove it;
•
Remove the front service panel (in all models it is secured with two M6 torx head screws on the
bottom and 2 M4 torx head screws on the top). The electronic control remains in its position after
you have removed the front panel. Pay attention to the electrical connection of the emergency stop
button. It must be disconnected to fully remove the front panel;
•
Remove the lower rear panel in all the models (M6 torx screws);
•
Remove the centre rear panel where the electrical connections will be made;
•
Remove the pallet, which is secured with 4 bolts in the same holes to be used to secure the
appliance to the floor using the provided dowels.
4.6
INSTALLATION AND ASSEMBLY
Attention!
•
The appliances must be positioned on a flat, levelled and solid
surface.
•
Refer to the technical attachment regarding the distances required
between the appliances and between these and the construction
work.
•
The appliance must be secured with the specific dowels if the floor is
wet or damp.
•
Check that the pressure - weight is equally distributed on the entire
support surface.
4.6.1 CONSTRUCTION WORK
