23
Follow steps 1 through 4 of the Grill Lighting
Instructions.
Then, push and turn the Infrared Burner Control Knob
to HIGH/IGN and press the electric ignitor 3 to 4 sec-
onds to light the burner. Hold the knob in 10 seconds
before releasing. If ignition does not occur follow step
7 before retrying.
After the Infrared Burners lit it will reach cooking
temperature quickly. The orange/red glow will even
out within minutes.
HIGH/IGN
OFF
HIGH/IGN
OFF
USE AND CARE INSTRUCTIONS
Grill Lighting Instructions
Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way, do
not use your grill before replacing the hose with an
authorized part from the Parts List. Also make sure all
gas supply connections are securely tightened.
Familiarize yourself with the safety and Use and Care
instructions in this manual. Do not smoke while lighting
grill or checking gas supply connections.
Be sure the LP Gas tank is filled or the Natural Gas Line
is attached to the gas source.
Open the Grill Lid
during lighting.
Check that the end of each Burner Tube is properly
located over each Valve Orifice (see page 20).
5.
4.
3.
2.
1.
Back Burner Lighting Instructions
Follow steps 1 through 4 of the Grill Lighting
Instructions.
Then, push and turn the Back Burner Control Knob
to HIGH/IGN and press the electric ignitor 3 to 4
seconds to light the Burner. Hold the knob in 10
seconds before releasing. If ignition does not occur
follow step 7 before retrying.
1.
3.
2.
After the
Back Burner is lit it will reach cooking
temperature quickly. The orange/red glow will
even out within minutes.
Burner Control Knobs on Control Panel
Set Control Knobs to OFF and open the LP Gas
SLOWLY 1/4 of a turn
. For Natural Gas
open the Shut Off Valve at source.
Push and turn the LEFT Main Burner Control Knob to
HIGH/IGN. Always light the LEFT Main Burner first.
Press the electric ignitor 3 to 4 seconds to light the
burner.
If ignition does not occur in 5 seconds, turn the
Burner Control(s) off, wait 5 minutes, and repeat the
lighting procedure. If ignition still does not occur,
turn the burner control(s) and gas source OFF and
conduct a leak test of ALL gas connections and gas
sources as explained in the Use and Care section
of this manual. If no leaks are detected, wait 5
minutes for any gas to clear and repeat the lighting
procedure.
After one Burner is lit, turn the tank valve SLOWLY
one more 1/4 of a turn for 1/2 of one complete turn.
Once one Main Burner is lit, the adjacent Burner can
be lit by turning its Control Knob to HIGH/IGN.
6.
tank valve
Open LP
gas tank
9.
8.
7.
Infrared Burner Lighting Instructions
1.
3.
2.
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding
to the Lighting Procedures could result in a fire
or explosion that could cause serious bodily injury,
death, or property damage.
WARNING
!
!
Follow steps 1 through 5 of the Grill Lighting
Instructions.
Open Range Lid during lighting.
Push and turn the Control Knob to HIGH/IGN. The built-
in spark ignitor will light the burner automatically.
You may have to push and turn the Control Knob up to
3 to 4 times to light.
If ignition does not occur, turn the Burner Control off,
wait 5 minutes, and repeat the lighting procedure. If
ignition still does not occur, turn the burner control(s)
and gas source OFF and conduct a leak test of ALL gas
connections and gas sources as explained in the Use
and Care section of this manual. If no leaks are de-
tected, wait 5 minutes for any gas to clear and repeat
the lighting procedure.
1.
Side Burner Lighting Instructions
2.
3.
4.
5.
OFF
HIGH/IGN
OFF
LOW
IMPORTANT:
Do not use the Back Burner and Main
Burners at the same time.
Grill
Range
Main Burner
Back Burner
Infrared Burner
Side Burner Griddle Burner
