16
Install Faucet Assembly
Slide open the Cart Basket Door and from the underside of the Sink Frame
unscrew and remove the Left Cart Rear Panel as shown. (See fig. 1).
Loosen 4 preassembled Wing Bolts 1/4"x1/2" half way and gently push the
Left Cart Rear Panel to slide along the designated slot to remove.
Insert the faucet as shown.
From the underside of the Sink Frame attach the 2 Faucet washers and
Bracket, then insert the 2 Hex Head Screws M4x20mm to the Bracket (as
shown). Do not secure too tightly.
Grip the faucet to sit flat on the Sink Frame top and screw the Bracket
(clockwise) from the underside of the Sink Frame to secure the Faucet
firmly into position.
Then securely tighten the 2 Hex Head Screws M4x20mm. (See fig. 2).
Insert one end of the water Pipe (not supplied) to the Faucet pipe outlet
(diameter = 5/8") and thread the other end through the rear panel as shown
to the water supply line of your preference. (See page 19)
Then also thread the loose end of the preassembled Drain pipe through
the rear panel to a suitable drainage pipe.
Align the slot and slide the Left Cart Rear panel closed and retighten the
screws.
Push the Cart Bracket Door closed.
For Operation instructions refer to Use and Care
on page 19.
6
Fig 1.
1
Lef t
Cart
Rear Panel
2
4 slots
3
Hex Head Screw M4X20mm
Qty.2
Part # S162M04201
Fig 2.
Sink Frame
top
Underside
vi ew
Hex Head
Sc r ew
Faucet metal
was her
Bracket
Faucet rubber
was her
5/8"
Faucet pipe
outlet
Outlet for Faucet
and Sink piping
