Grady-White Tournament 307, Руководство пользователя

Страница: 57 / 88

3 0 7 T
O U R N A M E N T
8–5
B
ATTERY
S
ELECT
S
WITCH
The 307 Tournament is equipped with four batteries and two select switches. The batteries are
wired into two banks, each bank consisting of two batteries paralled together. An outboard engine
should be connected to each battery select switch. Either engine may be started with either battery
bank by selecting position “1” or position “2” on the select switches. In normal use, select
position “1” on the starboard switch and position “2” on the port switch so that both battery banks
will be charged simultaneously by the engine alternators when the engines are running. The “1 +
2” position should only be selected in emergency situations when neither battery bank alone will
start the engines. Should this event occur, the switches should be returned to the normal settings
after starting the engines. The DC accessories on the boat will always be controlled by the
starboard switch. See
“Battery Wiring with Select Switches (Dual)” on page 8–20 or for a
diagram.
C
OCKPIT
S
HOWER
To operate the cockpit shower, the water pressure switch located on the accessory switch
panel must be in the “on” position. Open the cover and pull the shower wand out from the
recessed deck fitting. Depress the button on the back of the wand to spray water. To reinstall the
shower wand into the recessed fitting, gently feed the hose down through the deck and close the
cover on the deck fitting. The shower receives water from a 32 gallon fresh water tank. The water
pressure pump is located in the aft rigging area. Reference
“Freshwater System” on page 8–21
for a layout diagram.
S
EACOCKS
Ball valve seacocks are installed on the thru hulls for the livewell, washdown, marinehead
inlet and holding tank discharge. It is necessary for the seacocks to be in the open position for
operation. The open position is identified by the orientation of the handle. If the handle is in line
or parallel to the body of the valve, the seacock is in the open position. If the handle is
perpendicular to the body of the valve, the seacock is in the closed position. For seacocks with
remote arms installed, the open position can be obtained by pulling up on the remote arm attached
to the seacock handles. Pushing down on the remote arm closes the seacock.
C A U T I O N
Never turn the battery select switch to the “OFF” position with the engine running as this could
damage the charging system.
C A U T I O N
All seacocks should be in the closed position if not in use or if the boat is unattended to prevent the
taking on of water if a plumbing component fails.
!
!