Repair
34
334513N
Reconnect Pump
1. Reconnect the pump plunger (207) to the drive
shaft (9c).
2. While guiding the plunger (207) back into the fluid
cylinder (208), guide the fluid cylinder into the drive
cylinder (6a).
3. Apply threadlocker to the three set screws (6c) and
tighten them to restrain the fluid cylinder (208) to the
drive cylinder (6a). Torque the set screws to 15-20
in-lbs.
4. Verify the set screws (6c) are in the groove of the
drive cylinder (6a).
5. Tighten packing nut assembly hand tight plus a
1/16th turn.
6. Cover the packing nut (201) by threading the dust
cover (5) onto the drive cylinder (6a).
7. Reconnect inlet and outlet fluid lines to the pump.
8. Reconnect power to the motor.
9.
, page 23.
page 24.
11. Tighten packing nut as necessary to seal pump
plunger.
F
IG
. 23 Reconnect plunger to drive shaft
F
IG
. 24 Tighten packing nut
1
2
F
IG
. 25 Replace dust cover
2
1
5
6c
