Graco WB100, Инструкция-перечень запасных частей

Страница: 40 / 112

Operation
Fill Fill Fill the the the Fluid Fluid Fluid Supply Supply Supply
1. Follow the Fluid Voltage Discharge and
Grounding Procedure, page 39 .
2. Follow the Pressure Relief Procedure, page 39 .
3. Open the isolated enclosure door.
4. Remove the pail cover from the pail, holding a rag
over the suction tube strainer to prevent any fluid
from dripping into the isolated enclosure. Place
the cover and suction tube outside the enclosure.
5. Remove the supply pail from the enclosure.
NOTICE NOTICE
NOTICE
Be sure to wipe up all fluid spills in the isolated
enclosure. Fluid can create a conductive path
and cause the system to short out.
6. Clean up any fluid spills in the enclosure, using
a soft cloth and a non-flammable, compatible
solvent.
7. Fill the supply pail with fluid and return it to the
enclosure. Clean up any spills.
8. Reinstall the pail cover, holding a rag over the
suction tube strainer to prevent fluid spills while
you place the pump suction tube in the pail.
9. Close the isolated enclosure door and fasten
securely with the T-handle locking screw.
Startup Startup Startup
Follow all steps under Gun Setup Procedure, page 26 .
Before operating the system, check the following list
daily to ensure safe, efficient operation.
⃞
All operators are properly trained to safely
operate an electrostatic waterborne air spray
system as instructed in this manual.
⃞
All operators are trained in the
Pressure Relief Procedure, page 39 .
⃞
The electrostatics are turned off and system
voltage is discharged according to the
Fluid Voltage Discharge and Grounding
Procedure, page 39
, before any person en-
ters the isolation enclosure, before cleaning,
and before performing any maintenance or
repair.
⃞
The warning sign provided with the gun is
mounted in the spray area where it can be
easily seen and read by all operators.
⃞
The system is thoroughly grounded and
the operator and all persons entering the
spray area are properly grounded. See
Grounding, page 22 .
⃞
The Graco waterborne fluid hose is in good
condition with no cuts or abrasions of the
PTFE layer. Replace hose if damaged.
⃞
The condition of the gun’s electrical
components has been checked as instructed
in
Electrical Tests, page 47 .
⃞
Ventilation fans are operating properly.
⃞
Workpiece hangers are clean and grounded.
⃞
All debris (including flammable fluids and
rags) is removed from the spray area.
⃞
All flammable fluids in the spray booth are in
approved, grounded containers.
⃞
All conductive objects in the spray area are
electrically grounded and the floor of the
spray area is electrically conductive and
grounded.
⃞
Fluids used must meet the following
flammability requirements:
• FM, FM,
FM, FMc
FMc
FMc Approved:
Approved:
Approved:
Material does not sustain burning in
accordance with the Standard Test Method
for Sustained Burning of Liquid Mixtures,
ASTM D4206.
• CE CE CE---EN EN EN 50059 50059 50059 Compliant: Compliant: Compliant:
Materials which cannot be ignited, in any
mixture with air, by an energy source of
less than 500mJ.
40 3A2496H