12. To stop dispensing, close the air motor on/off
pilot ball valve (G) and the main bleed type
master air valve (B).
B
A
ti21575a
Figure 18
13. If needed, drain remaining fluid from system.
NOTE:
NOTE:
NOTE: Materials that separate more easily may
require draining the remaining fluid from the
system. Check material data sheet to determine
whether it is necessary to drain the remaining
fluid from the system.
a.
Place grounded metal drain pan beneath
pump lower inlet fittings.
b.
Remove hopper and fittings between hopper
and pump lower.
c.
Use a screwdriver to lift the pump lower inlet
ball. This will drain the remaining material
from the pump lower. When the pump stops
draining, release the pump lower inlet ball.
d.
Install fittings and hopper.
e.
Install camlock retaining straps.
f.
Starting at the pump, raise the hose bundle
above your head and slowly move towards
the applicator. As you move towards the
applicator, the remaining fluid in the hose will
drain from the applicator into the bucket.
18
332612C