Graco SDMM8, Инструкция по эксплуатации

Страница: 13 / 30

Operation
333492G 13
Operation
NOTE: The letters used in the following instructions
refer to Typical Installation on page 8 and the Compo-
nent Identification on page 10. Numbers used in the fol-
lowing instructions refer to the Parts List on pages 21 -
24.
1. Open fluid shut off valves (J and L).
2. Start pump (F) to pressurize system.
3. Adjust the air pressure to the pump motor so the
fluid pressure is no greater than 1500 psi (103.4 bar,
10.34 MPa)
NOTE: To ensure dispensing accuracy, before begin-
ning dispense, pull trigger to purge all air from the fluid
lines and meter.
4. Continue operation with instructions for Preset Auto-
matic or Manual Shutoff Valve Instructions.
Preset Automatic Shutoff
NOTE: Clean strainer (3a) regularly. See Parts, page
21.
The totalizer keeps a running total of the amounts dis-
pensed.
1. Turn meter pointer (41) counter-clockwise to select
the desired volume.
2. Turn automatic twist lock nozzle (101) clockwise to
open nozzle. Insert nozzle into the fluid receptacle
and pull the trigger (12).
NOTE : The trigger latches automatically. Do not set
trigger to enable meter to dispense when it is unat-
tended.
The meter shuts off automatically when the set amount
of fluid is dispensed.
Manual Shutoff Valve
NOTE: Clean strainer (3a) regularly. See Parts, page
24.
The totalizer keeps a running total of the amounts dis-
pensed.
1. Turn automatic twist lock nozzle (101) counter-
clockwise to open nozzle. Insert nozzle into the fluid
receptacle and pull the trigger (12).
2. Watch the meter pointer (41) on the meter dial (37)
move. Release the trigger (12) when the desired
amount of fluid has been dispensed.
3. Turn the meter pointer (41) counter-clockwise to
return it to “0” before dispensing again. See F
IG
. 9
SPLASH HAZARD
Do not trigger meter when nozzle is closed . Fluid
will build up behind the nozzle. Fluid can leak from
the nozzle and can unexpectedly be expelled when
the nozzle is opened. If the meter is accidentally trig-
gered with the nozzle closed, point the nozzle into a
waste bucket and slowly open the nozzle to relieve
pressure and expel the built up fluid.
NOTICE
To avoid costly meter damage, never turn the Preset
meter pointer (41) (F
IG
. 8) backwards (clockwise).
F
IG
. 8
41
NOTICE
To avoid costly meter damage, never turn the Manual
Meter pointer (41) backwards (clockwise).
F
IG
. 9
41